Click here to go back to home page EMAIL

 

 

Back Home

 

READ ALL OF THE INSTRUCTIONS­ BEFORE YOU BEGIN

Operating instructions for the Radon in water test kit are furnished to you with specific steps, which must be followed by you. If these instructions are not followed correctly, National Safety Products, Inc. cannot provide any warranty remedy to you for any claims, which arise due to the failure to follow instructions.

If you do not understand the instructions, STOP! - Do not use the detector until you have called or written for clarification by National Safety Products, Inc. 

The Radon in water test kit will measure average radon concentrations in your home or building water supply, which was present during the testing period. Radon concentrations can vary considerably throughout the year due to many factors. EPA recommends a follow-up test to obtain reliable information about your average annual radon exposure.

How to do the test:

1. Remove the aerator from the faucet (if one is attached).

2. Turn on the cold water & allow it to flow at a moderate rate for approximately 3-5 minutes.

3. Place a clean bowl under the faucet & allow it to fill up with the water from the faucet.

4. Remove the test-vial lid & fill it with the water sample to be tested from the bowl. Tap the vial while it is still underwater to remove air bubbles. Replace the vial lid while it is still UNDERWATER. Repeat this step for each additional vial.

5. Complete the data requested on the information form. Repack the vials & information form in the shipping carton.

ATTACH POSTAGE & MAIL!

Allow 3-10 days for your report.

 

 

 

 

 Important Note:

vial/s must arrive at the laboratory within 7 days from the date vial/s were closed or results will not be certified.

Did you Remember to:

· Complete the enclosed Information Form

· Place postage on the shipping carton

· Verify the shipping address & put a return address on carton

 

  

 

LIMITATIONS OF DATA AND LIABILITY

We maintain all data and other information strictly confidential and will not release it to other parties without specific permission from the customer, except where required by law. Information may be included in reports to the public but without reference to specific names or addresses. We do not accept responsibility for financial or health consequences or subsequent action taken by our customer or his consultants as a result of this analysis and sampling. We make NO WARRANTY OF ANY KIND, EXPRESSED OR IMPLIED for the consequences of erroneous test results. Neither National Safety Products, Inc., nor any of it's employees or agents shall be liable under any claim, charge or demand whether in contract, tort or otherwise, for any and all loss, cost, charge, claim, demand, fee, expense or damage of any nature or kind arising out of, connected with, resulting from or sustained as a result of any radon testing requested.

Radon Test Kits - as low as $9.95 (includes lab fees)

(EPA recommends side-by-side testing)  

1-877-412-3600
If you prefer to order by phone there will be a processing fee added to orders under $75.00

EMAIL  |  PRODUCTS  |   HOME

Here's a few examples of testing devices. Click here for full list

Radon Detector

Less than $100

Radon in Water

Less than $20

Radon in Air (48-96 hours)

Less than $10

Radon in Air (90-365 days)

Less than $20

 

The contents of these WebPages are copyright protected

© 1996-2008, All rights reserved NATIONAL SAFETY PRODUCTS, Inc.

Back HomeClick here to return to NSP's home page